Recent content by Rfarm

We got broken into last night. They were able to take the coin boxes out of the vacuum with minimal damage. Ran into our portal with their grill guard. And then started washing the vehicle in the self-serve while the other person was trying to drill out the plug lock on the coin box in the...

We had one nozzle on the side that was partially plugged it was hard to see until we took it off. Just had the deflection and the spray would mist over and spray extra water on the sonar. Wipe it and it was good for a few cars

Be sure your flex pass tips are not partially plugged. That can just mist enough to cause issues.

Is the sonar full of water? Take it off and turn it over and I bet water runs out

Probably not simple fixes but I know on and dump trailers the front of the trailer is narrower than the back end. The other thing if it would dump at a steeper angle by changing the stroke of the cylinder but I don’t know how much that would change The hinge points. I have got an old 450 and I...

I have a three year old razor that was doing the same thing a few months back. we had to replace the control board in the main panel box. Replaced it and it hasn’t blown past the car since. We tried sonar and checked all the wiring everything was good and the technician said he had never seen...

Correct/Mc liquid/foam additive mixed together. We run 2 passes of it. This works well me me and it’s reasonable

I ran jbs compas on our razor worked great at first then conditions changed. We checked and tweeked everything and could not get the film off. Went back to powder. It works great again

Just curious if anybody has tried the Kleen-Rite belts for a razor. I know they are listed for a PDQ but just wasn’t sure if they are the same belt on both machines. And also how they hold up compared to the wash world belts. Thanks

We have multiple coats of flaking 2 part epoxy paint inside our auto bay that are leaking into the block wall A LOT. We have a inverted L auto in this bay, so it sprays the walls a little more than some other machines. Is there a product that will stick to that paint to seal the water from...

Thanks for the help on my issue. I feel like my coverage is pretty good, but i am learning everyday.... We are putting 2 passes of this product on, after the first pass its all wet with product and starts running pretty good, then after the second its totally covered and running. That...

We are running a inverted L machine in colorado. Hot low pressure simoniz correct powder and mc liquid. We are doing OK on the cleaning, but not real consistent. At times it will leave streaks where the product ran down, I have tried more product, and less product, it didnt seem to help it...

Just acquired a 3 bay ss wash, and the bays have in floor heat that is not damaged. The concrete has settled and needs replaced. I am one that thinks outside of the the box so tell me what you think 1- use labor and hammer drills and try to slowly chip out the concrete and hopefully save the...

Thanks again. Would you buy direct from a manufacture if it was as close as a distributor?Is there any extra value in buying it through a distributor and being on better terms with them for other supplies. keep in mind we would be dealing on different machines but we do have a manufacture very...

Starting to look into a brand new touchless system. Which models would you recommend or try to avoid? I know a lot has changed in the newer model systems. We are looking to go with a brand new system and would love as much advice as possible. Thank you in advance.