Search results

There is a sticky thread about this. It has all the information you need. Read that multiple times if you have to. It can be done DIY. https://www.carwashforum.com/threads/the-nayax-problems-and-info-sticky.17758/

Any bearing supplier should be able to match up the existing bearing for a replacement.

Nice, may pick one up as a back up also. Cheap insurance. Triple foam gets used a lot at our locations. In a pinch, an arduino could be setup to do this pretty easily with some relays also

I looked into the traffic sequence cards after reading an earlier post. All I seem to find now are 85vac and higher, would require relays to work with the low 24vac controls

Listen to Randy, he is the resident Hamilton expert!

Would help to know brand and model of changer. Are your settings in controller and mars validator correct? Who refurbished the hopper? Some require the coin counting switch to be adjusted to count outgoing coins properly

Having a green color and nice scent tire cleaner is very important. We always see traces of green when we go to the washes. We get pretty good usage on our tire cleaner. We are dispensing through the HP gun with a flojet at 75 psi. Hope to change to cantbreak80 LP system this year.

I would buy a ginsan GS-30 triple foam timer if the PLC is actually bad. https://www.kleen-ritecorp.com/p-3760-ginsan-gs-30-triple-foam-timer-24-volt-ac.aspx

We were too late getting to one of our washes after taking too long at another wash. Already had frozen tubing and hoses, couldn't pump washer fluid through all the lines. We'll see in a few days how much damage we get...

We use those Amazon cheapies, we test them weekly, never had any issues. We drain for 5-7 seconds every 45 mins, so usually we hear it working at least once or twice while we are at the washes.

We are going to have to shut down tomorrow for a few days and looks like the weekend again will be shut down. Outside of Atlanta and going into the teens for multiple nights. This thread helps a lot, as we aren't setup to shut down. Will be using all the tips and tricks here.

Get an auto drain, they are well worth the cost and easy to install.

Make sure those any coins you are not accepting are turned off in the programming. May have bad electronics if it started accepting randomly and it wasn't accepting earlier. I would try to reprogram and go from there.

Most likely yes, but is it worth paying someone with the skills and knowledge to do the work? Maybe, especially since a new one seems to be $300+

Looks really nice. You may want to put tire cleaner as one of the top buttons. We have tire cleaner and presoak as the 2 top buttons to try to get customers to use those first. If you are doing cashless, you don't even need an external timer. The nayax will work as your timer. How are you...

https://www.carwashforum.com/threads/the-nayax-problems-and-info-sticky.17758/post-181243 This post may help you also Normally open, closes and connects the 2 wires on button push

Which attribute is that? It isn't needed for the external stop button as far as I know. As I said, I am using the configuration in that post and can confirm it definitely works. Those 2 attributes are all I changed and wired in the momentary switch as shown and it worked.

Did you get a license plate? We have successfully gotten reimbursement by showing police video of the damage being done and license plate

The configuration for an external stop button was posted already earlier in this thread. I can confirm it works, as I used this to add my external stop buttons and it works flawless. https://www.carwashforum.com/threads/the-nayax-problems-and-info-sticky.17758/post-184586

Is it even feasible for you to build a new wash. Very, very few instances now where it makes sense to build a new SS/IBA wash