Search results

Having purchased a used PDQ machine I don't see where anything has changed. I have never been able to get any kind of support from PDQ or harrels.

I saw Kleen Rite released a video on Cryptopays new tap credit card reader. My first thought is why didn't the make the swipe and tap into 1 unit? It appears you need the swipe head and the tap unit is an additional unit. Who wants junk mounted all over their meter boxes, vacs, and...

I do the same with WD40

buildasign.com

Can these signs be repaired if something should fail like the LEDs burning out or a bad power supply? I liked their 3 year warranty followed by they will work at least 11 years. Ok then why not an 11 year warranty? "FREE 3 YEAR WARRANTY - Our signs are built to last. If you leave them on 24...

I have an automatic wash at one of my washes that currently doesn't have a dryer. I was thinking of adding a drive thru dryer in the parking lot to service both the automatic and the selfserve bays if they wanted to. Like you said, just have a paystation for just the dryer.

It doesn't matter if you have a bay dedicated for muddy vehicles. If a muddy vehicle comes in and sees a bay they don't have to wade through mud they are going to use the clean bay. All bays will end up being mud bays if you allow it.

I do it on the razor. 2 Hi presoak passes, Lo triple foam pass, 2 HP rinse, wax, spot free

Thats to bad. They are very difficult to deal with. I had to jump through several hoops to order a part from them one time. Never used them since.

I apply triple foam over the presoak. No issues at all. I use a low PH triple foam as well.

I am in the process of installing 2 brand new airlift elite doors on my automatic bay and need to change a parameter in the lenze VFD that they use to work with my automatic wash controller. Unfortunately they have changed the drives factory password and I cannot access the parameters I need...

I would think everyone's cold water would be around the same temp being it comes from the ground. The tanks in the equipment room would be the only variable and its pretty safe to say everyone keeps their equipment room temperature above freezing.

Yea but you only want to adjust the methanol side, the soap side will remain the same, so put the solenoids on the methanol side and leave the soap side alone.

I like the date better than early spring.

This sounds kind of like the way my petwash is set up. There is 1 dema injector that goes to a manifold block with several solenoids that select which product is used. Each solenoid is a metering solenoid so you can set each ratio independently. Pretty much the same concept.

Tell them due to Covid you can't have large crowds.

That explains why the last vac hoses I ordered were junk. Started splitting after 3 months and I usually get a year or more.

Did they find the problem or just reset it? Big difference.

I second the aluminate from warsaw.

I believe it was $2.50 a liner foot for a sheet it 3 feet wide.