Search results

I have been looking to buy a wall mounted Glass spiral vending machine for a 6 bay wash. I have been looking at a few options from kleen rite and on the used market. Just wondering if anyone has any recommendations as to what is good for the money.

Yes the fuses control the contactor on the right which runs the pump, the one on the left is for the air dryer.

the contactor on the left is for our air dryer, the one on the right is for the pump, the other pumps are behind the other bays???? Not sure how the location of the other pumps is relevant to this situation.

Ya an electrician did that and everything seemed alright to him.

Not a bad shout! Thanks for sharing, I’ll have to look around and see if there’s any wires rubbing against anything, then again it’s just the fuses not the entire circuit. Still worth a look tho.

Lately, all 3 but typically it’s been one

Yes, each bay has their own individual box with the contactor and fuses that power the motor for the bays high pressure. There’s three 20 amp fuses in that box and those are what’s blowing, hopefully what I’m saying makes sense lol, was raised at this wash as it’s a family business so my...

I have this real strange issue going on at my 6 bay wash that I can’t seem to figure out, I have had electricians come by and take a look and they don’t seem to have any idea either. Every few months I have a stretch where the fuses for the high pressure motor in one bay constantly blow, nearly...

But no water nor persoak should be getting to the air regulator at all that’s where the leaks coming from, sorry I think I’m just misunderstanding what you said!

Not a bad idea! The only problem is the lines copper so it might a bit of a pain.

Its leaking from the air regulator on the air line after the solonoid for the air and before the check valve that goes to the drip and foam brush low pressure lines and their solonoids for the individual bay. Which leads me to believe either the check valve is no good (which I’ve just replaced...

I drain my compressor pretty much daily so it shouldn’t be that…. Btw you’ll break 80 one day

The air compressor? How could water be getting in there? I thought about that too but couldn’t figure out how that would be possible.

Hi all, lately I have had a small leak dripping down from an elbow that connects the air line to the drip and low pressure line for one of my bays. What is confusing me is that there shouldnt be any water getting through the check valve between the air line into the T that connects to the the...