Search results

Best way would be to setup a test jig to quickly swap out microcoin units to test quickly. You would basically just be unplugging and plugging units into the val board to test after you setup your test jig. You should have a spare timer on your shelf, not just for this, but as a backup to...

My nayax units have been fine all day. Is it all your transactions or just beacon mobile specific? Not familiar with beacon mobile or how it works

Pricing and spacing will be market dependent. Spacing will also factor 3 vs 4 packages. There have been many discussions of 3 v 4 choices. We have 4 right now, going to switch to 3 at 1 site and see how that goes. There are claims of higher ticket averages with 3 choices

And this is why we cut power to bays to close or work on them. People will move cones like they aren't there for any reason and try to use the bay. We have had people move cones, try to put coins in a powered down bay and then have the gall to complain it won't work.

There is a thread with pictures on this forum, you can find it with the search function.

I never had cryptopay, just went from hamilton system to Steve's system. I would try to get your hands on some stock parts and see if it works.

Have you talked to Steve about your issue? Also, what exactly is the nayax system doing that you are having issues with. We have his kit on an acw 4 and another on an acw 5, both work, though we do get the occasional hiccup with the nayax system

All of that plus maintenance costs and cost to run your memberships

You have to know the cost of your washes to see if you're profitable

The led6s with the new internal electronics don't work with nayax, I found that out the hard way. Timer never shuts off after nayax stops and sends stop signal.

We were trying to rebuild pumps, but anything more than a seal kit or valves and we now replace with a new one. It's not worth it for us time wise and parts are expensive. The pumps last 15-20 years, a lot of the ones we are replacing have served a good, long life. If the only thing wrong with...

Would be interested to see how that works and a wiring diagram for count up.

We have done this at all of our washes based on these forums, PS usage has increased significantly at all washes

Holy crap am I in the wrong business. $2k for that?

This will be the quickest and easiest way to see if it is a chemical dilution issue or another issue. Try this before messing with your tips. What chemical are you using?

Does this allow count up? Looks like a relay to get from nayax pulse to any timer in count down mode. It's not converting mdb to pulse

Mark 7 cleans way better than a laserwash. How many washes on your machine? Mark 7s are built like tanks, they will last with a little maintenance. Some parts for those machines are getting hard to find new, but mainly everything is still available on the secondary market

Where are you located? We did similar to a gto300 a few years back, there are positives and negatives to doing such a project. As waxman said, a new iba will run you north of $200k, so it's important to know if your site will be able to earn a decent roi on that type of investment

Are all 3 solenoids clear and allowing flow? Are all 3 hydrominders working properly and mixing chemical concentrations? Loose hoses or connections before flojet allowing air to get sucked in?