Search results

Will a washgear credit card reader work in the unitec? They sure cost a lot less and they look exactly the same. http://www.kleen-ritecorp.com/p-20652-cardmate-card-reader.aspx

washgear looks like it uses the same brand that is in the unitec's could their new reader that works on both sides fit the unitec?

The credit card reader in my 4 year old WSII is very hard for customers to use, you have to insert it and remove it very slowly in the correct position to get it to work, people sometimes get frustrated and leave, i tried cleaning it and that didn't work, it does this on both pay stations. Is...

It will make noise if it hasn't run in several hours but after one wash it is quiet again until it sits for awhile.

I use speed one to get all the soap off, it goes on really thick

The gearbox on the trolley is making noise when it moves left and right. The wash is only 4 years old, is the gearbox going bad or will changing the oil fix the problem?

I would join if you add IBA to it

I been trying to tweak the programming of my laserwash 4000 to get the best possible wash while trying to reduce wash time and decrease chemical and water usage. What would you suggest I change with the current program? The HP polysealant S is a clear coat and the drying agent is Lustra shield...

My four year old 4000 is always inundated with electrical issues and the washworld units i have seen are better about providing objective data to point to the problem area to fix

I checked every fuse, and eveything seems to work except the abb, could a bad contactor cause the fl 17 error?

A hose broke and sprayed water on the control panel for the laserwash 4000. It damaged the VT board, so I replaced it, the CPU works fine but the ABB speed controller says FL 17 which in the instructions says "analog input out of range, check AI level" What could be the problem with it, I...

I replaced the 20 amp breaker with a 20 amp QO-HID breaker and it solved the problem, it is designed not to trip with the initial rush of energy to start the metal halide lamps.

so if the nec says that a 12 gauge wire can handle 25 amps and my circuit uses 19 amps can't I just replace that 20 amp breaker with a 25 and as long as I don't add anymore too it and it will be ok? With the 20% rule 19 amps is border line but still fine.

I looked up the specs and each 250 watt metal halide uses 2.5 amps, and the 400 watt uses 4 amps, so thats a total of 19 amps, is it tripping occasionally because it is so close to 20 amps?

They are wired for 120v, it never had a problem before

I needed to add more light to the back of my IBA and I put a 400 watt metal halide floodlight up, it is on the same circuit as 6 other 250 watt metal halide lights, now every few days the circuit breaker trips, should I just replace the 20 amp breaker with a 25, or try a 20 amp breaker designed...

it is the one mounted on the t-bar, is there a newer one for the 4000's?

One of the colors on the triple foam shower is clogged it just foams and does not spray out, it is only doing it on one side, how can I fix it?

Hi I just got a glass front vendor and now I have 3 laurel single item mechanical vending machines, they are 3 years old and in great condition, how much should I ask for them?

Would it help to make the $5 wash $3?