Search results

It currently takes about 20-22 seconds for low pressure product to make it out of the gun from both starting out and when changing from function to function. I feel like this is too slow. For example my first two functions are tire cleaner and pre-soak. When time starts it takes about 22...

I had this exact issue a few weeks ago. MEP001 is probably correct. I tried everything else then swapped the pump with a new one I had as a backup so I can rebuild the old one, problem solved. I put a gun on a short hose and came straight off the pump to eliminate all of the hoses and valves...

We have music playing low in the bays. Not sure if it’s right or wrong or if anyone cares. It was on when I bought the was and I’ve just left it on.

So if the heater in the Hydrominder tank is set right can I get by with that for now? That tank holds about 4-5 gallons. I guess I’m thinking that it will not drain and have time to reheat before the next wash. The next question is do I replace the 100 gallon water heater or go to an instant on...

I just got my tire cleaner system working. It is low pressure with a Flowjet pump. It takes over 20 seconds to get to the bay when the function is selected. How do I speed this up? More air to the Flowjet? As a side note I notice that the line empties when not in use. Not sure if it is...

The hot water tank in my ss wash was bypassed long ago and the Presoak wasn’t functioning. I’m working to get it functioning again and replaced the heater in the Hydrominder tank. How important is hot water in Presoak? This is only a two bay in a small town so there Is never a line of cars. Can...

I don’t have a book on it but I do have the same system. Those are sight glasses for metering your high pressure soap and wax. one glass per bay. If it is like mine, follow the lines from your hp soap and wax tanks, they should go to a manifold and split depending on your number of bays. Each...

where do I send it to get bored and sleeved? Back to Cat?

here is a video of the gauge when the pump is running. I’m in the bay with the cycling the wand. The pressure is high when closed and falls to about 300 when the trigger is pulled.

I recently bought a 2 bay self serve. This is my first wash. On one bay the pressure would not go above 300. I changed the unloader, the gauge and put a new gun and tip on in the bay. That seemed to fix the problem for about a week. During that week however I noticed it would have 1100 psi...