Search results

Does anybody have any experience/opinions on Premier vacuums. Apparently they have been around for a while but I only recently found out about them. They have a nice large faceplate that seems more than ample to accommodate tap, swipe, digital timers, & bill acceptors. They also appear to be...

Looking to replace faceplates and was contemplating installing Cryptopay Tap Plus only (no magnetic stripe readers). Any comments or opinions on this would be appreciated. If the site currently has magnetic readers and switched to Tap Plus only would this cause a decrease in business...

If you only raised the wash bays by 33% then only that portion of the total income should increase. Perhaps the interested party is under the impression that you raised the prices on all your services (vacuums, vending, etc) by 33%. If possible break out the wash bays revenue, before & after the...

If I remember correctly the personality plug contains the coin pulse relay; If the relay is bad the timer will not get a pulse.

when you tried the coin acceptor in another bay did you also move the personality plug to the new bay? If not try replacing the personality plug in the problematic bay.

I have swipers and LED 9 timers.If I keep the swipers and add the TapPlus do I connect the Red/Green wires to the same timer terminal? Additionally how is the swiper switch configured to work with the TapPlus?

now that’s funny “slug rejector”

Thanks, here is the JE Adams link I was referring to. https://www.jeadams.com/replacement-parts/coin-acceptors/vacuums-combo-units/microcoin-ql/

Thanks, here is the JE Adams link i was referring to. https://www.jeadams.com/replacement-parts/coin-acceptors/vacuums-combo-units/microcoin-ql/

Will the Microcoin QL insert (actual acceptor) fit into any other mounting faceplate? The JE Adams website shows a Microcoin QL mounted in an all stainless faceplate. The faceplate they use for this seems to be similar to the IDX faceplate.

Where should the breakaway fittings be installed? At the inlet to the high pressure gun or at the end of the high pressure boom or both? Also , there are several types to choose from, Suttner, Mosmatic, etc. Any recommendations? Thanks

Is anybody else having trouble calling IDX. Verizon keeps telling me that "your call can not be completed as dialed".

Is this a ventless? if so, do you have a problem with moisture?

My old propeller 45000 BTU Reznor unit heater needs to be replaced. The equipment room walls are masonry and the roof is uninsulated metal. The dimensions are approximately 20 x 12 and the ceiling height is 11 feet. Initially, I was going to replace the heater with another 45000 BTU Modine Hot...

Can someone comment on JBS PC-180 tire cleaner? How does this compare to Kleen white. Is one product better than the other? Thanks

Over the years, I have had a number of different MEI acceptors in service. And yes, we have had problems with five dollar bill acceptance too. As strange as it sounds, I have noticed that if I crumple up and then flatten the five-dollar bill that the acceptor is rejecting, it improves the...

Tire chains (LOL)

Is that a load or no load current? Do you know what voltage is being applied across the transformer?

We just purchased several Coleman vacuums. Unfortunately, we do not have the keys. The faceplate has two barrel locks, and the coin drawer has a lock that requires a key that is semicircular. Can anybody provide, PM, with some guidance on drilling these locks? Thanks.

We just moved the TC & PS to dispense out of the Tri foam gun utilizing the existing 1/4 poly tubing. We used a flow jet g57 pump and the existing 5040 trifoam tips. Were are getting great coverage and lots of positive feedback. 2Biz, I don't understand how you came to the conclusion that...