Search results

X15,16and 17

Have you considered a CONFORM building? Basically, it is a concrete building poured into forms that become the walls. Cost effective and quick to put up. We used on the last wash I was involved with building. Full disclosure… I recently took a job with another wash supplier, and we represent...

2 membranes to produce 8K per day? if they are the standard size (40x4) you would be at max of 3600 gal per day, or 2.25 per minute.

Sorry missed your post.. back up ring(white) goes away from the pressure. Black oring towards pressure. The puck has a small hole in it, the hole towards the air. I like to see the air pressure for the valves at 10 psi per 100 psi of pump pressure. so 1000 psi pump equals 90-100 psi of air ball...

We have a couple shampoo vac combos. One is A Jim Coleman unit, other is a fragamatic. Both brand new. PM if interested

Out. Away from pump station

I timed the HV against the Razor. The same exact vehicle, both programmed identically. The Razor washed 16% faster. You should be able to wash even faster with the Razors by utilizing some of the flex features etc. I did a small sample however..4 washes only

Ver Tech has good chemicals. Lots of operators around here use them, I believe. Are you switching because of costs or poor performance?

Front eyes not rear eyes. :o

Have you tried replacing sheer bolt? Over time they can bend slightly causing lower arm to interfere with the rear t-bar eyes

I sent you a PM

Always used hard water, just wasting money otherwise

Will it effect the vehicle height you can accept in the two auto bays?

I was wondering about middle one myself. Yes PSI will need to get corrected, even so id expect your TDS to be lower. may need regulator or rebuild?? is it a 3 phase pump? may need to just switch a couple legs around to get the pump to turn in right direction,

Yes same here always when high dew points dryers just couldn't dry out. just get high pressure washer out and clean from time to time.one more job to add to never ending to do lists.

I'm assuming 2 membrane system.. If that pic is your system while running, the good water should be 2.25 to 2.5 gallons per min., looks like it’s over 5. Waste looks to be 1 gallon per min, I can’t read PSI, but as stated above 190-225max for two membrane system should be about right. I...

There are smaller orings in the end cap where the membrane meets the end cap. Usually two per.. The larger outside orings on the end cap are for stopping water leaking

Had a site that had spotting issues once. Turned out dyers were really dirty. Just a thought

When installing membranes the brine seal on the membrane must be at the solution side( where water enters the membrane). If installed correctly you should check that the orings in the end caps are good as stated above.

Merry Christmas