Search results

How does the Gin San 16D work? Thank you.

I have a Hamilton interface GL-ACW card system interface kit Part # 100-0064 installed on a Gold Line cashier. My question is about the green 7 screw terminal strip. I believe terminals 2, 3, 4, and 5 send 24V to the plc when the customer presses one of the wash buttons. I'm not sure about...

The display on our ACW5 is practically unreadable. Is it usually the display or the lens? Any help or suggestions will be appreciated.

I have a stainless steel tank that has a small leak. The tank is open to atmosphere and the water is heated to about 125 degrees F. I would like to drain the tank and put some type of product on the hole that will work under water. Any one know of something that will work when exposed to water...

A lot of work but it paid off. The previous answers are much better than mine but I will share a pit experience.A few years two men came to me and said they had dropped a valuable ring in the pit. I pumped out the water but they could not find the ring. They asked if they could shovel out the...

I am having a problem wilh a single phase Ingersol Rand air compressor. About every month or two it trips out the overload on the motor.It does not seem to be temperature related because it started back in the winter and it is not storm related. When it happens I push the reset button on the...

The voice system on my Gold line is not working and I do not have information on it. Can someone suggest what items to check. Thank you.

I have misplaced the sheet that has the three letter commands for a PDQ G5 series. Commands are used to move the bridge and other items. Will someone share a copy with me? Thank you.

It is a dual stacker and switch 4 is off. Hamilton told me about the purple wire jumper plug, but there must be something else.

No, I did not change the controller. I do not have a problem with the stacker but I am new to the forum and read in the archives where you could run without the stacker if you plugged the jumper into the harness. I did it as a dry run so I would know what to do if stacker failed. I reinstalled...

What do you have to do to run without a stacker in a Hamilton RL2 changer? I had been told to separate the harness going to the stacker and plug the purple wire jumper into the harness. I did this, turned it on and now I'm getting a 6-1 error code on the controller. Is there something else to...