Search results

I Loosened 2 Of The 4? Bolts Holding The Halves Together Enough So That The Bolts Bottomed Out Holding The Sections Together. It Has Been Working Fine About 6 Months Now, But There Is Still The Gap At The Clutch. Lav

My Passenger Side Treadle M-switch Got Cut, I Eliminated It Without Issues 4 Months Ago. Lav

Greetings, my PVC man doors have bowed so that light can be seen over an inch top and bottom when CLOSED. The manufacture said that I should not have painted them (DARK BROWN, OUTSIDE) , and their revised door with inner galvanized steel supports, now has a disclaimer if you paint them. When...

Thanks for your info Ben. Who's wax are you using? A Tri-foam wax also?

Suprisingly my 2 BC 1400's upgraded easily. But what about the MEI validator conversion? Is Rowe's setup designed well? I understand Capital Vending of Maryland offers a set up, but my experience dealing with thoes kids was frustrating, NEVER a return call after about 8 attempts of trying to...

My ozone reclaim w/cyclonic seperators has generated a black jello-like slime throughout the suction and output plumbing segments for over about 8 months. There is rarely if ever ANY hydrogen sulfide odor, but I flush out tanks less than a month apart, check settling tanks(only the bay pits have...

Tankless water heaters for heating presoak (HI-PH)? What heat exchanger lifespan are you getting, since copper or brass slowly dissolves away by the presoaks? Thanks

Jimmy Buffet, I sprayed the stud ends with pv blaster a few times over a week, but if they have not been apart for years, the reaction between the aluminum and the carbon steel locks it too tight to remove. But as for Ryko's "overpriced cyl" @ $158.19, Astromatic price is $134.25 and although...

Rykopro, could you please go into more detail on the oil contamination issues. I could understand if the lubricator put too much oil in the shaft side of the cyl., that might tend to force oil past the shaft seal or ?? . I'm just trying to minimize blowing the air down, pulling out the brushes...

Howdy, my wheelscrubber air cyls have leaking seals on the shaft towards the brush. I've gotten better rebuilding these, but now I want to put in-line lubricators on them. IF I understand this correctly, I should put 1 on each side(driver & passenger) on the cyl.return air line, the airline...