Search results

I dont have a diagram and all the wires are the same colour.

I've been wanting to do this for years, but I was always afraid of the wiring nightmare. Please let us know how the change-over goes. Will GinSan be providing any installation instructions?

I was wondering if anyone uses the Baymaster bay boxes from Exacta. I have Exacta equipment for my touchfree and would like to tie my SS bays in with it so I can offer wash codes, wash cards and credit card acceptance. I have looked at both the full Baymaster boxes and the retro boxes, but I...

Yes, thank you. All the ultrasonics were weak. After replacing both side sensors, and two on the gantry, it started working, and, solved a problem we have had since the unit was installed almost 7 years ago...

I've never seen the end stop lit with the unit at rest. It does lite up at the end though. Are they prone to sticking? I've never had a problem with one before. In fact, other than broken belts and a couple of worn out pullies, I have done very little parts repllacement on this unit in 5...

Still no go... Here is an update on what it is doing. Still turning into the side of cars and trucks intermittently. It ignores the arm tilt prox when it turns into the car and will happily trolly right across the car. Both end stop and front stop prox have intermittent glitches. I have...

Thank you guys for your input. Much Appreciated. Still looking for the problem, but I'm likely going to pull new wire and see if that helps. The unit has washed 110,000 cars, so it's likely gone back and forth close to half a million times. I've replaces most of the hoses over the past 5...

Well, I replaced the transmitter, ran several vehicles through, including pick-ups and full size vans, short cars etc. It seemed to be working fine. Then it turned into a buick. I'm at my wits end with this thing. I've checked wires, junctions, connections...

Not for a while, but last time I tried, they refused.

I can not buy from Ryko, so I pay whatever the 'factory authorized' company charges for them. 200% markup on retail is about average...

Yes. There was some variation, but no actual failure. I've decided to replace the rear ultrasonics. I hope that is the issue as it's going to cost me over $1500 just for the parts...

These are the conditions when it shuts down. And you have the correct schematic. It halts everything when the error happens, including tank filling. I'm leaning toward US failure, but the 2 digit error should show arm tilt since the trolley is trying to drive through the driver's door... I...

My 5 year old 2001 keeps trying to turn into the driver door intermittently. When it happens the whole system halts. Even the tanks stop filling. The ultrasonics seem to be working, as do the prox sensors. The lights on the computer show the arm pointing toward the passenger side at the time...