Search results

Count up with a $15 limit incase they forget to hit stop. Like Keno said you should not charge more for credit cards. You want to encourage credit card users they will be your best customers and you get to empty, unjam and service your coin/bill acceptors less often.

So I’ve been having this problem more and more and it’s starting to drive me crazy. My foam brush barbs keep cutting the hoses they’re in and then they leak at the base of the handle on customers. I’ve tried the little “motorcycle handle” guards. They don’t seem to help especially since they...

I think I’ve done it on my 310 pump by drilling a screw into it and using vice grips to pull it out a couple years ago, if it’s the 3 ring seals all the way back. I’m assuming it would be the same thing for a 5cp. I don’t think I’ve ever openned one of our 5cps but I assume they’re the same...

I figured as much, maybe I’ll open it and see if I can use it as a monitor for one of the camera DVRs

Im sorry to hear that. Thank you for letting me know. He was a really nice guy, saved me a lot of headaches.

Hey guys I have Coleman Hanna Swipe @ The bay with a box of swipers. Was wondering if it’s worth anything? Do people still use these? We switched to cryptopay a couple years ago so this has just been sitting in our electronics room.

Do you have a picture by chance? Im pretty sure I did this once before but I want to be sure its the seal I'm thinking of, the location I need to service right now only has 4 bays so I want to minimize downtime. I'm currently just topping off oil.

We have ours mounted on the wall, but ive been thinking of running a hose from the inlet into the attic.

I have the three phase but maybe my electrician could have wired it wrong? Do any of you have any photos of what it should look like?

About a year ago we purchased two Air Shammee II's. Immediately after install I noticed the guns leak from the trigger and the air is weak, even with the air blade attachment. Ive since removed the guns and put regular vacuum tips, the ones you use to get between the seats. They still are so...

I know I’m the photo it looks like the foot valve would be touching the bottom anyways but that’s because I had pulled it out to replace it.

The gunk isn’t an issue as much anymore. It seemed to mainly be my triple foams and I think it was because whoever set it up originally was pre-diluting before the hyrdominders. Our blue triple foam would accumulate blue flakes at the bottom. I’ve since changed it so that we don’t have to pre...

I came up with something similar a couple years ago. Not my best made one but it kept it off the bottom. I used much thinner conduit, I had extra laying around. I’ll probably just modify these if I can.

I use these on my automatic, only issue I have with them is if they sit on the bottom of the barrels of some chemicals they clog on gunk or sediment. Maybe I’ll try putting these in some inlet screens. The price is definitely way better than the blue ones. Will they hold up to harsher chemicals...

I’ve always used the Kleenrite plastic blue foot valves for my chemicals but they’ve been failing on me constantly these days. Even new ones I’ve just installed. Is this happening for anyone else or do I have bad luck? Does anyone have a brand that seems to fail less? They’re too expensive to be...

It also has a little hole on both sides

It’s not quite what it once was but I’ve one out.

I need to rebuild pretty much all the solenoids. There’s four bays and 3 of this type of blocks. The blocks should be fine. I’m trying to find the plungers.

Photos of the valves. I tried pulling up the stickers, didn’t seem like the original ones were under it

Trying to find the plungers so I can rebuild these valves. Does anyone know who makes Carolina pride valves? Last time I called it was very difficult to get ahold of someone who could tell me what I needed then they just wanted to sell me the whole Block instead of the plungers. From what I...