Control Boards

[cmcclu]

Would any one be kind enough to share any ideas on how to correct a JC control board (self serve) that is stuck on only one function and will not change.

I assumed that the control board was the problem but after replacing it with a different board it still will not operate or is still stuck in only 1 solenoid position. Not sure what e lse it could be besides the control board. Thanks!

 

[Tom Thumb]

Need more info. as to what it is or is not doing.

 

[Buzzie8]

My experience JC conrol boards has been that you need to send them back to BNC Electronics for repair when they act up. I have done this too many times to mention on my combo vacs control boards. Never for my SS yet though. I am assuming that you have the keyboard pushbutton controllers.

 

[cmcclu]

The function selector is stuck and will not move. Typically I can "unplug" the board and that will clear up the problem however this time it does not. I replaced the board with one that is properly operating and it still will not move.

 

[MEP001]

The function selector? Are you talking about a rotary switch, or is this a keypad?

 

[cmcclu]

It is the key pad style that has a light that will light up on the function that has been selected.