What's new

How to mix the powder soap (simnoiz Correct)

petes car wash

New member
Joined
Mar 10, 2017
Messages
2
Reaction score
0
Points
1
Location
canada
What is the easiest way to mix powder soap . Do you fill 55 gallons drum with hot water and then add 50 Ib simnoiz correct powder into it, or you do in small batches . Do you need to stir it or just close the cap and shake or roll the drum?
 

CarWashBoy

Active member
Joined
Apr 24, 2015
Messages
262
Reaction score
119
Points
43
Location
USA
If I may ask, why are you thinking of powder soap? Am I missing something? I will try anything..
 

Randy

Well-known member
Joined
Sep 5, 2007
Messages
5,861
Reaction score
2,222
Points
113
At one wash we mix it in small 5 gallon batches in a 15 gallon container. If you mix it in a 55 gallon drum it's easier to mix it in the 55 gallon drum if you use a barrel mixer. Add about 20 gallons of hot water, then start adding the Correct as your filling the drum with the mixer running. Wear a mask while your adding the Correct, it can get dusty.
 

petes car wash

New member
Joined
Mar 10, 2017
Messages
2
Reaction score
0
Points
1
Location
canada
At one wash we mix it in small 5 gallon batches in a 15 gallon container. If you mix it in a 55 gallon drum it's easier to mix it in the 55 gallon drum if you use a barrel mixer. Add about 20 gallons of hot water, then start adding the Correct as your filling the drum with the mixer running. Wear a mask while your adding the Correct, it can get dusty.
Thanks Randy,
What tip I should use for high pressure soap in self serve car wash. I want it to come like milk and how much foam additives I should add in 55 gallon drum.
 

Waxman

Super Moderator
Joined
Aug 31, 2007
Messages
6,050
Reaction score
1,695
Points
113
Location
Orange, MA
I remove pickup tube, fill 55 gal barrel half full with hot water. Add 50lb correct. stire with a wash brush. add 1.66666 gal foam additive, stir and fill to top with hot water. Takes just a few minutes.
 

Waxman

Super Moderator
Joined
Aug 31, 2007
Messages
6,050
Reaction score
1,695
Points
113
Location
Orange, MA
Thanks Randy,
What tip I should use for high pressure soap in self serve car wash. I want it to come like milk and how much foam additives I should add in 55 gallon drum.
Just keep bumping up the tip size till you get it the way you want...
 

washallday

Member
Joined
Jan 25, 2018
Messages
90
Reaction score
14
Points
8
Location
Pa
I add the correct into 55 gal drum using a big funnel. Then add drum 1/2 full, use drum stirrer on drill mix. Then I add two 5 gals of purple passion and mix then fill the drum up with water mixing in between. Great show and cleans with nice smell. This cost around $175.00
4175.00
 

mjwalsh

6 bay SS w/laundromat
Joined
Sep 7, 2007
Messages
3,134
Reaction score
173
Points
63
Location
North Dakota
Petes Car Wash,

Specialty Equipment of Mpls-St. Paul, MN area .... before they left the car wash world ... had a nifty powder soap tank - combo wax tank with a screen etc above the soap side where it would be held liquid below. It also has a port for pH triggering so the soap could be kept at the same consistency. It would mix smaller amounts as needed when the pH sensor would tell it. Sheldon Russell actually did do a good job of inventing that IMHO. We improved on it so we can easily switch from liquid to powder but still use the same pH sensor.

I would think that the other manufacturers have something similar &/or possibly better??? It is possible some distributor still sells that specific dual purpose rectangular tank???

Not sure ... but it seems like the pH sensor trigger control setting could be adapted to any car wash powder including Simoniz.
 
Top