cleaning up mud
Member
Anyone know how to adjust the time each color runs in the tri foam guns in the bays?
JC SS bay tri foam
- Thread starter cleaning up mud
- Start date
cleaning up mud
Member
I dont see a controller for it, I have no idea. Three sold.valves what controls them dont know.
MEP001
Well-known member
Their stand-alone trifoam systems had a controller that was not adjustable. If it runs off the main controller, that would have to be adjusted in the program, not something you can do in the field.
You could always add a controller. I don't know if there's an adjustable one - I use a programmable relay. Go look at the trifoam at the 4/1 Dale built around 2001. It's running my program.
You could always add a controller. I don't know if there's an adjustable one - I use a programmable relay. Go look at the trifoam at the 4/1 Dale built around 2001. It's running my program.
cleaning up mud
Member
Did you install it later on? He didnt have one at first when matt was still around. our d&s is burnet has never worked good, the jc has always worked better.
MEP001
Well-known member
Yes, I installed it around 2006.
The D&S 5000 trifoam was a bad design since it sprays through the high pressure tips. We're running a Vector which has foam pods, but it can run through the high-pressure arches too. I switch it to arches in the winter because the trifoam lines freeze, but there's no foam, just color soapy-looking liquid.
The D&S 5000 trifoam was a bad design since it sprays through the high pressure tips. We're running a Vector which has foam pods, but it can run through the high-pressure arches too. I switch it to arches in the winter because the trifoam lines freeze, but there's no foam, just color soapy-looking liquid.
Greg Pack
Wash Weenie
The PLC runs the tri-foam. As far as I know it's not field adjustable.
