LW 4000 Friday help...

[MDrost1]

Folks,
Had to do a cold start yesterday on my 4000. Had a right limit no flag error. I swapped the right limit switch. However, PDQ forgot to tell me to switch my system option number. Well I called back and we got it squared away.

Now I have an issue where the trolley is not measuring the passenger side. It either goes wide or, way short and causes an impact error. Been washing cars fine until this stuff. Thoughts? I have run direct line from j0. Have tried two x30 proxes. Never had this issue till today. Thanks!

 

[MDrost1]

Ok, went back to my old system option number and it works???

I have vt, weep, acw4, and lasermind, lasernet. What system option number should I be using?

 

[MDrost1]

Update:

The new "system option number" I received was wrong. Causing the issue. I have the correct one in the J0 now. With this setup, the width measurement should be set to "4" and all width measurement adjustments should be made in the VT controller.

Running well now.