What's new
Car Wash Forum

This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

LW4000 VT Question

MDrost1

Member
Hello!

I have been getting some VT errors. In the "1" position my #6 LED
blinks. In the manual it says that when the wash restarted, the VT did
not and is out of sync.

What can cause this? Is it a part failure or customer error? PDQ said it could be caused by a faulty RY10 relay. it hasn't happened in a few days. Wondering if it is dire. It doesn't seem to affect anything...I think : ). Any help
would be appreciated. Thanks!
 
Ok I'll give it a shot. workin off of memory here.

With the VT controller switch in the 6 oclock position(i think thats 0) you can press the button and clear the errors and alarms.(or whatever you call em, the stuff on 1 & 2). After that, turn the power off for at least a minute and then turn it back on. see if that clears it up. Past that I'd have to do some studying.

I can tell you that there are a couple different VT manuals out there. I have one that is an older revision and it has some info in it that is not correct. Drove me absolutely bananas until I got confirmation from PDQ that it was bad info. I also have one that IS correct. I'm sure you already know this but it is a good idea to keep the VT manual handy with your PDQ manual. I have all the settings noted in mine for easy reference. Take good notes while you are working on it and write them in the margins for future reference.

Hope this helps
 
Back
Top