Earl Weiss
Well-known member
- Joined
- Aug 31, 2007
- Messages
- 6,372
- Reaction score
- 943
- Points
- 113
Bought a model TS 1811 to replace the unit I use for cleaning the tunnle and optional HP initial rinse for snow and ice.
Don't recall what I replaced but specs were about the same. BUT, the slot in the existing bushing for the pulley was slightly narrower than the key that fits in the General pump shaft. What gives? Do I jsut order the pulley KR has listed for general pumps - 24mm?
Don't recall what I replaced but specs were about the same. BUT, the slot in the existing bushing for the pulley was slightly narrower than the key that fits in the General pump shaft. What gives? Do I jsut order the pulley KR has listed for general pumps - 24mm?
