Saw from quest?
- Thread starter jack954
- Start date
MEP001
Well-known member
It says dilute anywhere from one part water to 30, so obviously you have to adjust it to your needs.
Greg Pack
Wash Weenie
Depends on how dirty, I often use it at 1:1-4:1. It isn't as effective as an HF based product at the same dilution but I use it quite a bit and like it. I can let my employees use it without worry.
Car_Wash_Guy
Well-known member
I tried some and wasn't impressed at all. Maybe I didn't use enough or let it dwell enough but it most certainly isn't as effective as Klein Wall
DiamondWash
Well-known member
I used to love Kleen Wall from AP Formulators until the new blending company got their hands on the mixture and added HF and not in a small percentage as they are telling customer's it's WAY more!
Last edited:
Greg Pack
Wash Weenie
Yeah, I'd agree that it doesn't work as well as HF based product. It does however, work on some alkaline scale residue better than HF in a side by side comparison. But I won't let all my employees use HF and this stuff is safe for them to use
soapy
Senior Member
I use low fume Muratic acid from Home Depot. dilute it 3 to 5 parts with water. Brush or spray it on and let it dwell for a minute then a light scrub and rinse will usually clean about anything and it is much cheaper than anything else I have ever found.
Greg Pack
Wash Weenie
Soapy have you used that on extrutech? I seems I remember reading that it can make the plastic brittle.
soapy
Senior Member
I have used the Muratic acid on FRP, Famr tec poly max walls and stainless steel with no problems.
