soft gloss arm issue

[Jimmy Buffett]

The rear arms on my soft gloss are hitting really hard when they go back out. I just had a pm done and the form said that he checked it but I'm sure it is hitting too hard. Which valve controls that? What should the pressure be?
I have a new camera inside my auto bay that I am pretty sure is going to give me ulcers! I may have been better off not knowing how bad people drive!
Thanks

 

[NJpdq]

The rear arms on my soft gloss are hitting really hard when they go back out. I just had a pm done and the form said that he checked it but I'm sure it is hitting too hard. Which valve controls that? What should the pressure be?
I have a new camera inside my auto bay that I am pretty sure is going to give me ulcers! I may have been better off not knowing how bad people drive!
Thanks

You would check the rear arm return gauge pressure should be around 60psi. There is also a brass flow control you could close that a bit until the arms start coming back more slowly..

 

[Jimmy Buffett]

The pressure seems ok. Maybe I just need to get used to the camera on the wall! It's kind of freaking me out.

 

[RykoPro]

You need to adjust the brass flow control for the rear arm return as NJ sugests. It controls the retraction speed of the rear arms.

 

[Jimmy Buffett]

I got it, thanks! I think most of it was getting used to my new camera in the bay.