Uncle Sam
Member
We have heard operators express the desire to upgrade their old vending machines, but getting the money to do so is tough in this economy. Therefore we are making this offer to those of you with existing Vend-Master units that are unreliable or not working at all. (See V-Blog #43) Rather then throw everything away, you can send us the working bill validator and coin changer (must be MDB compatible**, see below) from your Vend-Master as a trade-in on the cost of new bill validator and coin changer (Conlux--$500/Mars--$725). We will install them into a new ShurVend Junior FL or RL with LED lighting and the “Guaranteed Delivery” system. The list price for the ShurVend Junior FL with new Conlux bill validator and Conlux coin changer is $4495 and the Junior RL (rear-load) with the same Conlux equipment is $4795. After we receive your check for payment, we will send you a Visa Gift Card for $250 as a bonus that you can spend anyway you want. The net cost to you for this program would be $3745 for the ShurVend Junior FL and $4045 for the ShurVend Junior RL plus whatever the shipping with lift-gate costs to your location.
The ShurVend Junior FL or RL require a hole that is 32-inches wide by 35-inches high. The FL and RL “footprint” into your equipment room is 28-inches (if you have an 8-inch block wall) because the vendor trays are full size. In addition the rear-load RL vendor needs space behind it to pull out the trays, pull out the service chassis, and stand behind it to service. The hopper (drop box) in both vendors is large and the clearance between the tray and the window is over 8-inches so the taller car wash packs vend very well.
**All MDB units install the same way in any vending machine. The way you can tell if you have MDB units is the coin changer has a single 6-pin male plug and bill validator has two plugs; a 6-pin male and a 6-pin female wired in parallel.
Uncle Sam
The ShurVend Junior FL or RL require a hole that is 32-inches wide by 35-inches high. The FL and RL “footprint” into your equipment room is 28-inches (if you have an 8-inch block wall) because the vendor trays are full size. In addition the rear-load RL vendor needs space behind it to pull out the trays, pull out the service chassis, and stand behind it to service. The hopper (drop box) in both vendors is large and the clearance between the tray and the window is over 8-inches so the taller car wash packs vend very well.
**All MDB units install the same way in any vending machine. The way you can tell if you have MDB units is the coin changer has a single 6-pin male plug and bill validator has two plugs; a 6-pin male and a 6-pin female wired in parallel.
Uncle Sam
