Meter box custom decals

[Rudy]

I need a good recommendation for custom meter box decals.

I remember reading something recently (on the forum), but I can't find the link.

 

[Greg Pack]

STA-CARWASH.COM

Showcasing a variety of high quality meter door decals, menu boards, changers and signage to upgrade & personalize your busi

stacarwash.com

 

[soonermajic]

Greg is correct. But don't try to drive there. It is very difficult to find. ha

 

[edredtop]

I need a good recommendation for custom meter box decals.

I remember reading something recently (on the forum), but I can't find the link.

Kleen-Rite just announced they are making coin boxes in-house and if you click on the video link I'm including, at 2:05 Phil says they are making the decals too. Hope that helps.

 

[sparkey]

STA-CARWASH.COM

Showcasing a variety of high quality meter door decals, menu boards, changers and signage to upgrade & personalize your busi

stacarwash.com

To bad they don't include any prices on their website.

 

[Greg Pack]

To bad they don't include any prices on their website.

Their prices are reasonable. A few months ago I ordered some customized Coleman full face meter door decals and custom aluminum-backed menu boards. The meter decals were 40.00 each and the menu boards 80.00 each. It would cost you close to $80 to buy lexan menu boards and add the function strips from Kleen rite. The meter decals were the thick 3M material. I handle most correspondence via email and turnaround time was from final proof to shipping was less than two weeks.

 

[soapy]

I had some that. were done locally and they only charged me $12.50 each. I had a extra from earlier order and they just copied it.

 

[Greg Pack]

I had some that. were done locally and they only charged me $12.50 each. I had a extra from earlier order and they just copied it.

That's a heck of a deal!

I will say what I ordered was a standard pattern and all they did was a little customization to what they would consider a stock decal- my customer service number, some crypto instructions, etc. A few years ago when I started with a blank canvas for several vacuums and had a lot of back and forth changes they charged a design charge.

side note- I've always just done measurements and can get them close but not perfect. A guy I know uses a piece of poster board and a scalpel or x-acto knife to make a pattern for his sign guy. He said that gets them perfect.