SplishSplash
Self Serve Operator
I have two issues that I can not figure out:
Equipment is Coleman
First, spot free pressure to the holding tank is less than 1gpm. I replaced that membrane and I am stilling getting the same pressure. Bypass the filter and pressures are normal. I doubled checked to make sure the filter was not in backwards, now what???
Second, replaced procon pump on the tri-foam and still not working with a different problem! The motor starts making a clicking noise and runs intermediately, meaning it is clicking on and off. I replaced the motor with a spare, same problem. If I remove the hose going into solenoids everything runs fine. The solenoids are getting power and I can hear the air in the bays....
Thanks in advance!
Equipment is Coleman
First, spot free pressure to the holding tank is less than 1gpm. I replaced that membrane and I am stilling getting the same pressure. Bypass the filter and pressures are normal. I doubled checked to make sure the filter was not in backwards, now what???
Second, replaced procon pump on the tri-foam and still not working with a different problem! The motor starts making a clicking noise and runs intermediately, meaning it is clicking on and off. I replaced the motor with a spare, same problem. If I remove the hose going into solenoids everything runs fine. The solenoids are getting power and I can hear the air in the bays....
Thanks in advance!
ressure is measured in pounds per square ince, or psi. The number you are giving is flow in gallons per minute, probably read from the flow gauge, a verticle instrument, not a round pressure gauge. Most RO systems will produce that flow. Are you sure you have a problem? Did you test the TDS of the RO water? Your second issue sounds like you have a bad bladder tank. It will be about the size of a 5 gallon bucket. It keeps the pump from cycling too much. When the internal bladder goes bad it does this to the pump. Hope this helps.
