Eric H
Well-known member
I have one wash that uses centrifuge pumps on an open loop to deliver presoak and tire cleaner. I know this is a rather old set-up but this wash does not have a heated trough so I cannot switch to flojets. One of the pumps is beginning to leak from the motor seal and will need to be replaced very soon. I would like to upgrade to a medium pressure (100-150psi) pump over the low pressure (50-60psi) pump that is there. Can anyone tell me if I will have issues running a procon continuously? the motors look to be continuous duty but are the pumps?
Also, could someone recommend a motor/pump combination that would feed 4 bays? I see some combination units listed in Windtrax but Kllen-rite and Dultleier list them seperate. I want to make sure I buy everything I need the first time.
Thanks, Eric
Also, could someone recommend a motor/pump combination that would feed 4 bays? I see some combination units listed in Windtrax but Kllen-rite and Dultleier list them seperate. I want to make sure I buy everything I need the first time.
Thanks, Eric