Recent content by Indiana Wash

Does anyone know of any companies that repair Dilling Harris Touch Select Millenium Doors? I have one that needs some work.

Where in the process do they get their cut? That is not what has been represented to me by cryptopay or Worldpay.

No you are correct the new econo DAN without the box is $1800. According to my recent conversation with Hamilton, you can’t expect anything computer based, like the DAN, to last more than about 5 years. I would rather replace a $375 coordinator than an $1800 DAN every 5 years. My DAN was...

What do you mean the rate is increased? $0.06 plus .25% is extremely low for any processor. What rate is increased when???

Are you sure? I know worldpay charges $0.06 plus .25% but those are the standard processor charges. That’s what my bank charges. With the DAN, I also get an extra charge for E-xact. Are you saying that cryptopay also has an additional charge like this???

My effective rate for Hamilton is: $0.40 to my credit card processor for a $10 transaction (my average) $0.13 to e-xact $0.11 DAN computer cost over its 9 year obsolescence $0.06 DAN additional equipment readers and computers during its period of obsolescence $0.70 or 7% with a DAN. Too high...

I don't think so, but E-xact charges an amount in addition to the credit card processor. Crypto uses World Pay as the processor so you don't have to pay twice.

Did you call Cryptopay? I am switching to Cryptopay. Their coordinator costs around $375. The DAN system cost me $3400+ when I bought it and it is obsolete. Apparently, according to Hamilton, 10 years of use out of their equipment is a long time. I only got 9 years of use out of my DAN...

Fragramatics quit allowing anyone to resell their products. You will have to check their website and order directly.

OK, my Dilling Harris touch select doors have Microcoin QL coin acceptors. One went bad. I cannot find the acceptors with the right harness. The harness that is attached goes down to 4 wires. I did find this harness at Kleenrite. Can anyone tell me whether it may be the same as the one...

OK, my trough on my roof is galvanized steel. It has rusted apart. Do I just find a company that makes ductwork and order what I need? Has anyone found anything that comes insulated that works easier or better or lasts longer? Thanks

It bothers me to throw away $100+ a month in the vacuum cleanouts. I am sure last month was $200+. If I just grab the coin on top, I can get $20+ of silver without touching the copper or digging through the trash. Does anyone reclaim that coin or does everyone send it to the landfill. I was...

Fixing an unbroken machine by replacing it with a discontinued machine with proprietary parts seems questionable. I recently had to replace a pdq blower wheel and the only place to get the aluminum wheel is directly from pdq for $2200 for an aluminum blower wheel.

I own a wash and am helping a buddy convert a SS bay into an auto. If you had your choice, which IBA would you use? His SS bays are large. It will be a busy location attached to a gas station with only on IBA. If you are a retailer, feel free to pm costs.

I own two PDQ LW4000's. Recently, the drivers side tire that engages the rail and moves the bridge toward the rear of the car has begun to spin. I replaced the rollers and the tires and it still spins unless the pressure is 45 lbs. The only difference I could find between this rail and the...