Search results

As a noob, I’m still getting my bearings, but I’m constantly perplexed by when I think we’re going to have a slow week because of heat/weather, local events, etc. that we wind up busy. When the weather is nice and not Much seems to be going on, it’s crickets and dry bays during the day. Almost...

Do happen to have a good number for Hamilton? The ones I googled didn’t yield much.

Do happen to have a good number for Hamilton? The ones i got from Google didn’t reach Hamilton directly

That’s right, the bound cable is most certainly what cause these stripped gears. Buckeye, do you sell this item?

?

Alright, this thing is my problem. It’s some type of turbine flow totalizer meter that actuates the control gear of my softener. The small plastic gears in the meter gearbox are stripped. Has anyone seen this and know a part #? All I see is LF1 stamped in the brass and don’t see exact matches...

Nevermind, I see the plungers. They appear to depress correctly when I rotate a coin through.

Yes the arm returns to position just fine. I checked coin switch lash based on your method. It seems to be perfect… what do you mean by “both” switch plungers?

Motor brake seems intact

If it’s too tight, what would that cause? Do I want the “click” to be on a hair trigger, or do I want a decent amount of travel? I’ll look for this motor brake.

The red light below is blinking twice (disabled from system) the green light on the controller is blinking 3x pause, then 4x pause… so 3,4,3,4

I ordered Hamilton changers 100-0395 switch. It’s a newer part number than the switch I had, but it worked and I managed to adjust it very easily. I’ll check for the sequence later when I get to the wash. It was 2 or 3 flashes and it had something to do with communication error. Lost my pic of...

All, I have a hamilton dual bill changer. One of the hoppers will dispense 1 extra quarter when changing a bill ($1=5qtrs, $5=21qtrs etc.) the problem follows whichever changer I put the problem hopper in. Hopper part# 11-0100 -I already replaced the counter switch, same issue -error light...

If they actually have power and work otherwise, make sure your socket is clean and corrosion free. It’s a rough environment up there and I’ve had bulbs not work due to oxidized/dirty sockets a few times

How do I meter flow? I know the rated gpm for the automatics high pressure pumps. I can probably find the RO’s, but how do I ballpark the hydrominders?

I will be for the moment, but I intend to put a charcoal filter in soon

When I said 1” I meant the in/out pipe diameter. If that’s incorrect, please advise. I belive the current setup is plumbed wrong. The softener outlet feeds EVERYTHING except IBA’s and toilet. Ideally I’m going to soften water for ONLY IBAs, SS chemical blending and ROs. What could max gpm...

Yes! I love starting from square 1 and knowing my stuff in and out. any particular model clack valve you like? Is generic amazon reason ok, or is brand name worth it?

No, it isn’t going through salt. The outlet hardness is 17 grains which is why I’m troubleshooting this thing. Dunno if it’s actually shot or if the timer isn’t operating… or both The salt in the tank is multi-colored like someone put ice-melt salt in it. If so, could that ruin the resin? I’ll...

Those pics I just sent were taken months apart and it just occurred to me that the arrow on the control gear is pointing to the same spot like it hasn’t moved.