Search results

I came into a no wax issue in my auto bays and found my air compressor tripped off on motor overload. I reset it and it fired up but didn't sound that good. It is a Kobalt 60 gallon Cast iron oil lubricating with 155 PSI max. It seemed like it took frever to reach 100 psi and when it did it...

Thanks..I traced each wire out and found thermostat in attic by hatch..it was covered up with insulation and had the bulbs sticking out in the eaves..found loose wire on this and adjusted the temps and is working like it is supposed to now. Thanks for all your help!

WELL I GOT IT!! I swapped a bunch or relays around in the PLC and the relay box that has the vehicle detector wired in to it and also found a couple loose wires. Also tracked down the UC switch and found broken wire! Took a few hours of following everything through but PUMPED that it is...

Ok using the PLC or computer system on the door contol function..I can open the door just fine but it will not allow me to close the door. When I push the button the relay lights up with the # 6 output that correspondes to "enter door close" but nothing happens. There is not a emergency button...

Ok I didnt think the photo eyes would have anything to do with it. I know for sure in the two junction boxes on both sides of door..only the photo eyes and that small medal pad thing the door rests on is the only things that are tied into system. There are no open and close buttons located in...

Thanks Mike for such a quick response! I can shut it and open with operator garage door button..and the door opens when someone purchases a wash..dont bleieve it was responding the last time I tried to do it with the wash controller. SO these Photo eyes also can sense temp? They are factory...

I actually have a good question right now..Where do I look if one of my enter doors on the Auto bay is not closing on temperature? The other bay shuts on its own when a car enters or exits but don't know where to look to fix the problem. I was told the little pad by the door that is wired into...

I need some help with a Fututra by Specialty Equipment Company. Model NO SSA-9100C I am just getting into the biz and could use some..well A LOT of pointers!