What's new

Air Valve needed

David Rolf

Active member
Joined
Sep 24, 2019
Messages
144
Reaction score
99
Points
28
Location
Oregon
This weekend I have an air shutoff valve go bad on my tire system. This valve is 115Volt and turns off and on the air flow to the my flojet. The inlets are 1/4 pipe. Looked on Kleenrite and they seem to out of everything. Anywhere else I can locate one online that you guys know of? Also these are normally closed when not on correct? Thanks

1649091016766.jpeg
 

Randy

Well-known member
Joined
Sep 5, 2007
Messages
5,860
Reaction score
2,211
Points
113
I would think that any 1/4" 120 volt solenoid valve would work, all your doing is tur on and off the air supply to the pump. I'm a little surprised that it's 20 volt, most them are 24 volt.
 

MEP001

Well-known member
Joined
Aug 30, 2007
Messages
16,665
Reaction score
3,946
Points
113
Location
Texas
Use a DEMA 401P 120V. They're easier to wire safely, and Kleen-Rite should have them in stock.

Someone just stuck a 120V coil under the cap of the 24V one.

FWIW you can remove the plunger from the solenoid and run the system without air control for a weekend rather than have a system down. Most washes with Flojets don't even have air controls for them.
 

David Rolf

Active member
Joined
Sep 24, 2019
Messages
144
Reaction score
99
Points
28
Location
Oregon
Use a DEMA 401P 120V. They're easier to wire safely, and Kleen-Rite should have them in stock.

Someone just stuck a 120V coil under the cap of the 24V one.

FWIW you can remove the plunger from the solenoid and run the system without air control for a weekend rather than have a system down. Most washes with Flojets don't even have air controls for them.
MEP, Thanks for the reply and this solves my problem. Much appreciated. David
 
Top