This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
First time posting on this forum. I changed oil on my 2 Cat pumps on my gantry and now cannot get gantry to run. It is now showing a F5 alarm. All the water tanks are full. I checked most of the fuses and reset several times. Do not know what to try next. Any help would be appreciated.
I went back on alarm log and found 9 E7 alarms before the F5. So I started looking for a blown fuse. Sure enough as soon as I replaced fuse then the water tanks started working properly. The fuse kept blowing today as it went to spot free rinse. A bad solonoid coil going to ground was causing the problem. I was just about to make a
I went back on alarm log and found 9 E7 alarms before the F5. So I started looking for a blown fuse. Sure enough as soon as I replaced fuse then the water tanks started working properly. The fuse kept blowing today as it went to spot free rinse. A bad solonoid coil going to ground was causing the problem. I was just about to make a service call but solved problem. I did talk to a Mark 7 tech who led me in the right direction.