Changer Problems
- Thread starter Noob
- Start date
edredtop
Well-known member
A "wiggle" test may be helpful.
Slowly move the connections and wiring to see if it changes anything.
Slowly move the connections and wiring to see if it changes anything.
Unfortunately you can’t replace the bill box sensor yourself, you’re going to have to send it in for repair. When the bill box is installed how much up and down play? You should only have about .030 up and down movement on the bill box when it’s installed on the validator. If the Blue bill box catch is missing on the validator this can also be part of your problem. How old is this validator? When was the last time it was serviced? If you need a spare validator I should have a few.
I had the same thing happen to me , a couple years ago. Sorry to say I don't remember how to fix it, but I did call American changer, and they talked me through it.
I had an intermittent issue like this on one side of my American Changer some years back. It was the push-in connections on the door board at the top left corner. (your middle photo)
Take a tiny jewelers screwdriver and work them out and back in until the insulation on the wire is not interfering with the connection.
I had just converted over to CC Talk which required replacing all the components and one side had this problem. When I figured it out, I re-worked the other side too.
No matter how you anchor that cable down, the connections still get "worked" somewhat when you open and close the door, so the connection has to be pinched really good between the wire and clamp jaws.
Take a tiny jewelers screwdriver and work them out and back in until the insulation on the wire is not interfering with the connection.
I had just converted over to CC Talk which required replacing all the components and one side had this problem. When I figured it out, I re-worked the other side too.
No matter how you anchor that cable down, the connections still get "worked" somewhat when you open and close the door, so the connection has to be pinched really good between the wire and clamp jaws.
Well have you got this problem sorted out?
I haven't done anything yet. I've been busy with other things. I still have a roll of plumbers tape propping up the bill box and haven't had an issue since I did this. I know its not a long term solution. I'll try and get it sorted out this week.
Randy,
I’ll remember that next time. I had already ordered a replacement from KR. They matched me up with at talos 6 validator. I went to install it today but the bill acceptor doesn’t fit through the faceplate on the changer. Am I doing something wrong or do I have to modify the faceplate?
I’ll remember that next time. I had already ordered a replacement from KR. They matched me up with at talos 6 validator. I went to install it today but the bill acceptor doesn’t fit through the faceplate on the changer. Am I doing something wrong or do I have to modify the faceplate?
Attachments
MEP001
Well-known member
You may have to take the faceplate off the old one.
You need to swap the bezel from the old AE2600 validator and put it on the Talos validator, it'll fit. The problem with buying a validator from KR or any of the other big box guys is they don't know anything about them. I get calls regularly from someone who bought a validator from one of the big catalog guys and they are having problems with them and they want me to fix it for them. There have been a lot of problems with the Talos validators.
That's good. Yes we repair validators.
traveler17
Well-known member
You should’ve consulted Randy first about anything validators
, he’s the man