What's new

Check valve replacement as well?

Yeaux

New member
Joined
Aug 20, 2024
Messages
19
Reaction score
1
Points
3
While chasing down a pressure drop/water leak on the roof of our self serve wash we found a busted hose near this manifold (believe that’s what it’s called?). We are replace the supply line from the cat pump up to the roof and the whip from the manifold to the top of the boom. In you personal experience should I change out the check valves while it’s broke down? What about the push on connections for chemical supply lines, would you change those as well? IMG_7849.jpeg IMG_7850.jpeg
 

Yeaux

New member
Joined
Aug 20, 2024
Messages
19
Reaction score
1
Points
3
The check valves and fittings are roughly 10 years old.
 

edredtop

Well-known member
Joined
May 28, 2009
Messages
320
Reaction score
351
Points
63
Location
California
While chasing down a pressure drop/water leak on the roof of our self serve wash we found a busted hose near this manifold (believe that’s what it’s called?). We are replace the supply line from the cat pump up to the roof and the whip from the manifold to the top of the boom. In you personal experience should I change out the check valves while it’s broke down? What about the push on connections for chemical supply lines, would you change those as well? View attachment 12052 View attachment 12053
No check valve for HP?
 

OurTown

Well-known member
Joined
Nov 8, 2017
Messages
3,653
Reaction score
1,413
Points
113
Location
Ohio
No check valve for HP?

I don't think you need one there. Ours does not have one there but there is one on the pump outlet. I'm considering one above the bay to possibly prevent the siphoning I'm noticing now that we raised our ceilings by 5'.
 

Randy

Well-known member
Joined
Sep 5, 2007
Messages
5,860
Reaction score
2,211
Points
113
If it's not broke don't fix. I would clean it up the manifold, replace the hoses and reinstall it.
 

cbchevy4x4

Active member
Joined
Jun 6, 2020
Messages
181
Reaction score
176
Points
43
I usually replace check valves as needed, when one fails for a bay i usually go ahead a replace all of them for that bay. If i had it that far broke down id probably go ahead and replace just to not have to fool with it a week later after tampering with everything.
 

Greg Pack

Wash Weenie
Joined
Sep 3, 2007
Messages
4,391
Reaction score
2,169
Points
113
Location
Hoover, Alabama
If possible I would consider shortening your hose from the manifold to the boom. The low pressure changeover time might improve a little.
 
Top