I have an issue with my i5000 presoak application. The gantry moves toward the rear of the car and stops at the bottom of the arches and on the way back up the presoak stops around eye level. The tips still have air coming out but no presoak. The pump continues to run until the thermal overload kicks in. It does this every time. The odd thing is that when I engage the presoak using the output monitor it runs perfectly. I was able to get the presoak to work during the entire wash but I had to reduce the pressure to about 50 psi which is well below the normal 300. Any suggestions will be appreciated.
Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
D & S i5000 presoak problem
- Thread starter Jim64
- Start date
My bad, looks like I need to explain further. The presoak is fed by a recirculating system and when the presoak stops coming out of the gantry tips the pump continues to run. When the water gets too hot the hot water overload opens on the pump. I think it has to be a power issue to the presoak solenoid although it is still getting power. I haven’t put a meter on it yet to see if it is dropping. What gets me is that it is happening at the same time every time.
