I have 10 position 2 stack Electroswitch rotary switches that won't even last a year. The meters are only 2 years old and this is the second time i've had to replace them. Is this common? The switches won't turn when they fail.
Electroswitch Failing
- Thread starter APW
- Start date
cantbreak80
Maybe I need new clubs
Get yourself some seal nuts...
www.digikey.com
and some silicone grease...
Squeeze some grease into the switch‘s stem and use the seal nut instead of the nut supplied with the switch.
This is especially important if your coin boxes are inside the “wet zone” of the bays. It won’t stop the problem but it will extend the life of the switch.
N9060X1/4 2 APM Hexseal | Switches | DigiKey
Order APM Hexseal N9060X1/4 2 (335-1136-ND) at DigiKey. Check stock and pricing, view product specifications, and order online.
and some silicone grease...
DANCO 0.5 oz. Silicone Faucet Grease 88693 - The Home Depot
The Danco Waterproof Silicone Sealant Grease is ideal for lubricating faucet stems, valves and cartridges when repairing a leaky faucet. Silicone Faucet Grease helps reduce friction provides long-lasting
www.homedepot.com
Squeeze some grease into the switch‘s stem and use the seal nut instead of the nut supplied with the switch.
This is especially important if your coin boxes are inside the “wet zone” of the bays. It won’t stop the problem but it will extend the life of the switch.
Greg Pack
Wash Weenie
When they get hard to turn I've spayed mine with a penentrant ( I use sili-kroil) and within 24 hours they turn easy again.
copperglobe
Active member
What they all said.
If you want to tear a stiff one apart (it'll be tough to get it put back together) to just see what's going on. The stiffness is from where the rod goes through the housing or threaded part of the switch. Apply a very generous glob of that grease on the stem where it enters the housing and then screw on that Digikey nut.
If you want to tear a stiff one apart (it'll be tough to get it put back together) to just see what's going on. The stiffness is from where the rod goes through the housing or threaded part of the switch. Apply a very generous glob of that grease on the stem where it enters the housing and then screw on that Digikey nut.
MEP001
Well-known member
I use the boot and Sil-Glyde. I always have some on hand because I do my own brakes. It's much thicker than o-ring or faucet grease, but it still flows better into crevices and is not going to wash away.
I do the same with WD40
tdlconceptsllc
Well-known member
I thought electroswitches are the ones to have vs shalco they get real sloppy and off to me am I wrong
MEP001
Well-known member
Electroswitch is definitely a lot better than Shallco in that regard, but they're both steel and will rust.
Rotary switch problem
For 30+ years I used Electroswitch 8 position rotary switches. They were practically bullet proof. On a very rare occasion I would have to replace one because it became hard to turn. Nine months ago I added some new services and went to a Shallco 10 position rotary switch. I have already had 2...
www.carwashforum.com
