front license plate protection

[madstack]

Just had Belanger Quickfire Wraps installed. Turning in a small percentage of front plates. Would like a resource of sturdy plate covers or encasements as they tend to have flimsy or no protection at all to begin with. I could sell them at cost as good customer service.

 

[Earl Weiss]

Erie Brush

http://www.eriebrush.com/proddetail.asp?prod=832030

Product ID 832030
License Plate Holder Discounts Apply !
16% Discount off List price for 25 or more of this Product
9% Discount off List price for 10 to 24 of this Product
Details

License Plate Holder
License Plate Holder - Slide in from Side Type

Use them on my own car. Pretty heavy gauge. Can make then stronger by inserting lighter gauge sheet metal with the plate.

 

[Washmee]

I would suggest something a little nicer if you are going to have the customer pay for the bracket. These brackets are more modern and are pretty much a universal fit.

http://www.carparts.com/details/Replacement/License_Plate_Bracket/F017304.html

http://www.ebay.com/itm/UNIVERSAL-F...R-BUMPER-/160976976471?_trksid=p2054897.l4275

http://www.jcwhitney.com/replacemen.../p3039079.jcwx?skuId=1189167&filterid=c1836j1

 

[Earl Weiss]

What Washme posted are brackets. What I posted are hoders that use existing brackets. Thought about this for my own car but adding them where no nracket exists makes it stick out further. You can dress it up by adding a "Frame" of the customers choosing from any auto parts store. (Which is what I did.)

 

[Washmee]

Almost every plate I bend with my wraps are on vehicles that don't already have a bracket. Toyota and Nissan are the worst offenders. If you are bending or damaging plates that are already in OEM brackets, you might want to consider adjusting your wraps so they are not so aggressive.