Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Hamilton Dual Stacker
- Thread starter Earl Weiss
- Start date
dbrown2911
Member
I have a Hamilton model RNS with a c2000 controller. I keep getting 4 flash pause then 3 flash code with corresponds with a COIN DROP FAULT. Nothing seems stuck..everything appears to be working...I have a few extra hoppers and the code remains the same. Any ideas? Would appreciate your help thanks!
dbrown2911
Member
MEP001
Well-known member
Remove the eight screws that hold on the side cover, flex the stainless sides out a bit to remove the plastic guard, you'll see it.
Clean under the switch in case there's dust and crap built up - that can cause your problem too. You can swap the pairs of wires between the two stacks of the switch, just be sure you get them back on the right terminals.
http://www.kleen-ritecorp.com/p-11623-hamilton-changer-part-11-0008-dual-coin-switch-for-hopper.aspx
Clean under the switch in case there's dust and crap built up - that can cause your problem too. You can swap the pairs of wires between the two stacks of the switch, just be sure you get them back on the right terminals.
http://www.kleen-ritecorp.com/p-11623-hamilton-changer-part-11-0008-dual-coin-switch-for-hopper.aspx
dbrown2911
Member
Thanks! Will check into this as soon as I can after I get off of my other full-time job lol!
dbrown2911, STOP!!! Don’t move the wires around on the coin switch!! If you put them on the wrong terminal you can damage the controller. If you have to replace the coin switch don’t use the 11-0008 switch. Hamilton has come out with an newer easier to install switch #100-0151, it’s a few dollars more, $42.70 list. Since your inside the Hopper look at the Hopper bowl. If it has a grove worn into the bottom of the Bowl it needs to be replaced.
