IVS 140001 Vacuum - Adding Dixmor LED7 Timer
- Thread starter RAAOO7
- Start date
tdlconceptsllc
Well-known member
MEP001
Well-known member
You'll need to add a transformer and a relay. These are what I use:
www.kleen-ritecorp.com
www.kleen-ritecorp.com
Transformer primary hookup is backwards, white goes to line and black goes to common (white). Yellow will go to yellow on coin acceptor and red on timer, blue (common) will go to black AND one red/green on coin acceptor, green on timer, and one of the two 24V inputs to the relay. Other red/green wire from coin acceptor goes to brown on timer (coin +). White from timer (timed load) goes to other 24V input of relay. White main common wire still goes direct to motors, black main line goes to input of relay, output of relay to motors. 12V DC horn connects to orange and blue wires, polarity must be correct (Orange to +). Cap any unused wire leads of the transformer and the timer.
Above instructions are for Ginsan/IDX/other timers with yellow, black, and two red/green wires. If yours has yellow, black, and blue wires, ignore the red/green above and connect blue to brown on timer, rest is the same. Do not connect purple wire of acceptor to anything if there is one.
Kleen-Rite Corporation - Multi-Volt Input Transformer
Multi-Volt Input Transformer
24 Volt Relay | Mercury Relays Part 35NO-24ATH
The Mercury 35NO-24ATH is a 24VAC, normally open, 1-pole relay for motors or lighting. Hydrogen back-filled.
Transformer primary hookup is backwards, white goes to line and black goes to common (white). Yellow will go to yellow on coin acceptor and red on timer, blue (common) will go to black AND one red/green on coin acceptor, green on timer, and one of the two 24V inputs to the relay. Other red/green wire from coin acceptor goes to brown on timer (coin +). White from timer (timed load) goes to other 24V input of relay. White main common wire still goes direct to motors, black main line goes to input of relay, output of relay to motors. 12V DC horn connects to orange and blue wires, polarity must be correct (Orange to +). Cap any unused wire leads of the transformer and the timer.
Above instructions are for Ginsan/IDX/other timers with yellow, black, and two red/green wires. If yours has yellow, black, and blue wires, ignore the red/green above and connect blue to brown on timer, rest is the same. Do not connect purple wire of acceptor to anything if there is one.
