JC Parts Buyers guide part 2

[cleaning up mud]

i have gotten both from our baldor dealer! and the repair gears for the ocillators. and the wheel brush motors, wb's are a pain to repair!

 

[cleaning up mud]

Just a note to let you know that when I needed to replace the Omron SRT ID16 card in my WW 1.0 JC wanted $431. I found it locally for $279.50 at Hy-Tech Sales in Plum, PA. Here is their website:

http://www.hy-techsales.com/

theres a place that repairs them. i have spares they fixed. Im sure you know them, but I forgot the name.

 

[DJGall]

How about the Turck capacitive proximity sensors?? I have bought these in the past from Applied Industrial Technologies www.applied.com

but, there has to be a less expensive source.

Thanks!

 

[MEP001]

Kleen-Rite has some of the most common ones. mouser.com has other brands that will work.

 

[txheat]

automationdirect.com. part# AK1-AN-4H. Prox substitute for turcks prox. I recently replace 2 and working just fine!

 

[txheat]

I know this is an lod thread but here is great find for the tie rod ends for a WW 1.0. I was replacing these twice a year in the past but these have held up great for an entire year and they still are not worn. Paid $2.99 each for them. Just ordered a new set. One word of warning, while they hold up better than anything else I have used they squeak! Here is link to Amazon. This the only place VXB bearings sells them:

http://www.amazon.com/gp/offer-list...e=ur2&camp=1789&creative=390957&condition=new

i put excess grease that ooze out of bearings on them. they seem to last longer than the ones i spray galvanized. plus it get rid of the squeaking.

 

[txheat]

automationdirect.com. part# AK1-AN-4H. Prox substitute for turcks prox. I recently replace 2 and working just fine!

sorry for not being clear this replace the prox
ID#1645353
Ni12U-Em18WD-AN6x-H1141/S1163