What's new
By:
Car Wash Forum

This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Je adams vaccum hose

D

Damoni88

Active member
Doea anyone know if there is a part you can by to just push hose in to inlet hole? Im so tired of having to fight with this issue where you cut a peice of the end of the hose and thread it in. Any suggestions much appreciated and Happy Easter!
 
I will agree it is not the easiest thing to do but I have never had to cut the hose to get it started into the vac. It might take a couple of tries to get the groove lined up with the teeth on the vac.
 
mac said:
My guess is that if you made it easy to install, it would be easy to remove.
Click to expand...
On the Coleman vacs I have, you just push the hose in .. every now and then someone pulls one out, but I rarely have the problem. I do have a couple of older RoChemco vacs that are a little looser, but I just have to have a single wrap of duct tape around the end and the hose fits in tightly.
 
Well the je adams vacs do not have the push in method. It is a threading method that have to be turned counterclockwise and its not am easy task. I really like the vacs but this is really annoying especially when you can only get like 2/3 vac threads in.
 
Can you remove the tab, or whatever catches the threads? If so, you could probably push it far enough into the can to screw a cuff on from the inside.
 
You must log in or register to reply here.
Back
Top