Laser 4000 with VT

[zed 9]

our Laser 4000 has the Virtual Treadle measuring, my question is where is the X22 for width measurement?
The old floor plate treadle had X22 sensor up in the trolley on the main support plate, so when the VT retro kit came out where did X22 move to

 

[koliver]

You should have a VT board on the left side of your JO cabinet. The width measure sensors replace the X22 prox and go into the VT board.

 

[PEI]

Pin 2 on the J2 connector for the VT card. It's the upper right hand terminal and should be labeled output.