Looking for a rail stand for a PDQ 360+

[Monte]

I have purchased a used 360+ that has wall-mount hardware for the rails. Does anyone have a stand, in any condition, they would sell that would work?? or trade me for the wall mount hardware??

PDQ wants a ridiculous amount of money for a NEW SS stand. I have 2 other 360+'s that are operating on, I assume, the earlier generation galvanized stand...I am also wondering if anyone has mounted PDQ rails on a WW stand or competitors stand???

FYI...I prefer wall mounting, but at this site, the bay width is too much. Or has anyone built or fabricated brackets for a wide bay application.
Your comments or advice on the project, will be appreciated.
Thanks

 

[Keno]

Might be worth having a local fabricator/welder or 2 come out to see what they would charge to build your stand or brackets.

 

[STXCW]

How wide is the bay?

 

[Monte]

I will have to get back with that number. We are removing McNeil short tunnel and replacing with pdq 360.

 

[Monte]

Found out yesterday, the bay is actually 16'8". Which actually works with the LONG wall mount brackets from PDQ that are hopefulluy, coming.

I still am going to have to figure out the height issue, cause I have windows to 112" on the side wall. We believe the rail normally is 106" off the floor.

 

[water guy]

I have some rails from my lw 4000

 

[Monte]

It is/was the stand for the rails that I needed...I think now, wall mounts will work....Thanks