I’m replacing all my rotary switches and wire connections. Anyone ever use this terminal strip disconnect on the wires for the rotary switch to the 18/15 control wire for the quick disconnect? These have the screw on wire connection. No crimping. My old wiring has the molex 15 pin crimp connector. I hate all the crimping! I thought with this strip-type you could mount the female side to the inside of coin box and the male side to the wires from rotary switch. Seems like it would work good.
Meter box wire connector
- Thread starter Don B.
- Start date
I think they just plug in. I think the screws are for the wires. But I could be wrong. I looked at the phoenix style. There pretty expensive. These were a little lower cost. They will be enclosed in the meter box so they should be fairly well protected. I think I’m going to try them.
Greg Pack
Wash Weenie
I've used those types in the distant past and I don't recall any issues. I think it was a D&S system, but don't know if they used them or if it was just the independent installer's choice.
I’m going to try them. Seems pretty handy. Don’t have to do all the crimping!
GoBuckeyes
Self-Serve and Automatics
Don, once you figure out which phoenix connector you want just go on ebay and buy them. I bought a whole box for a fraction of the cost.
That’s a good idea, thanks
