Order of drying, CCP, etc...

[soonermajic]

Towards the finish, how do you guys do the order of : Drying Agent/Wax/CCP, etc.?
If you only used CCP & Wax, which would come first?
Do you apply them all on lp, or any hp?

 

[Greg Pack]

That's probably a question better suited to your chemical provider familiar with your products.

I use Quest and put the foamy products on first, then top with the liquid products that help kill the foam.

I use a polymer (oil free) drying aid and it goes on last. It is so diluted it almost doesn't spot

 

[washnshine]

I’ve used a few different brands over the years and the DA has always been last. Foamiest waxes first, then the clear sealers, then DA. But you should always check with your distributor. Jason told me at Quest that I could put on Vantagloss and then total shield without rinsing the Vantagloss off first. The total shield can go right over the Vantagloss.

 

[APW]

I’ve used a few different brands over the years and the DA has always been last. Foamiest waxes first, then the clear sealers, then DA. But you should always check with your distributor. Jason told me at Quest that I could put on Vantagloss and then total shield without rinsing the Vantagloss off first. The total shield can go right over the Vantagloss.

I actually use Jason's Total Shield and Shine On on a dual barb injector and it works great.

 

[washnshine]

I actually use Jason's Total Shield and Shine On on a dual barb injector and it works great.

Must be an explosion of tropical and fruity scents!

 

[Greg Pack]

I actually use Jason's Total Shield and Shine On on a dual barb injector and it works great.

I've done the same in the past and it does work well.

 

[soonermajic]

Seems grneral rule of thumb: Foam, CCP, Wax/DA.. ..