What's new
Car Wash Forum

This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

original vendmaster

Bubbles Galore

Active member
I need some help in trying to figure out how I can change over my coinco acceptor on my front vendor to accept dollar coins. I have talked to a few people and they all tell me their is no way. I am sure someone is smart enough to be able to do this if it hasn't been done yet. The acceptor I have is a two tube dispenser, one for nickels and one for dimes as change. The quarter all fall into a tray in the bottom of the unit. Send me your best ideas! I don't want to hear buy a new vendor either, if I could afford it I would, this is just for the short term.;)
 
Last edited:
Does anyone know if the logic boards are interchangeable between the vendmaster I & II? I contacted coinco and they said that the type of acceptor I have is basically extinct. I have a call into D & H to see if they can come up with something. Anyone have any info?
 
Vendmaster

You likely have an Automatic Products CS-12. It was marketed with two types of controllers - MDB or non-MDB. Find out which one you have through a local "vending" distributor. Then you can decide which of the Mars/Coinco/Conlux you need with $1 coin capability. D/H wrapped stainless around and marketed it as vendmaster. Good Luck!
 
:( Well, after a few days of talking to techs at D/H and at Coinco. They have come to the conclusion that there is not an upgrade available for my acceptor. Oh well, Shurvend here I come
 
:( Well, after a few days of talking to techs at D/H and at Coinco. They have come to the conclusion that there is not an upgrade available for my acceptor. Oh well, Shurvend here I come!
 
Back
Top