Replacing old compressor
- Thread starter randall
- Start date
Waxman
Super Moderator
This is what I use. It's one of my best pieces of carwash equipment.
http://www.championpneumatic.com/Champion_Product.aspx?id=2520&n=490
http://www.championpneumatic.com/Champion_Product.aspx?id=2520&n=490
Bubbles Galore
Active member
I got an Ingersoll Rand and love it...80 gallon...5 HP...230V...$1k at TSC.
cantbreak80
Maybe I need new clubs
Not Husky? My experience varies.
I bought a Husky, similar to the VT6315, 30 gal vertical as a temporary air supply while awaiting parts for my expensive IR 80. I fixed the IR two weeks later but never put it back in service. That was eight years ago.
The Husky powers all the low pressure systems for my 8 bay...including air assist for all lp functions, Flojet pumps for FB, TC, PS, FB antifreeze, and softener brine injection. Oh...and, blow down for the foaming pre-soak and tire cleaner guns.
Now that I've bragged about it I suspect I'll have to junk it within the next week.
I bought a Husky, similar to the VT6315, 30 gal vertical as a temporary air supply while awaiting parts for my expensive IR 80. I fixed the IR two weeks later but never put it back in service. That was eight years ago.
The Husky powers all the low pressure systems for my 8 bay...including air assist for all lp functions, Flojet pumps for FB, TC, PS, FB antifreeze, and softener brine injection. Oh...and, blow down for the foaming pre-soak and tire cleaner guns.
Now that I've bragged about it I suspect I'll have to junk it within the next week.
In fairness to Husky, mine was not a top of the line model. But, it was just used to power a flo jet running 4 foam brushes. After about 14 months it suffered a catastrophic failure. The pump pretty much ate itself. One afternoon I noticed I had no pressure and a good sized pile of metal shavings under the compressor.
Whatever you do DON’T get an oil less air compressor. They run to fast and won’t hold up in a high use environment. The slower a air compressor runs the longer it will last. I’ve got a 20 gallon Sanborn air compressor at my wash that has been running for over 15 years. Since I put it in I’ve replaced the motor start switch and one pressure switch. I’ve also got a 30 gallon Saylor Beall that’s over 30 years old in the shop. The only thing I’ve done to it is replace the pressure switch. It runs very slow, the pump turns at about 500 Rpm. There’s nothing wrong with a Husky air compressor I know a few that have been in service for a number of years. Speed kills an air compressor fast.
How old is this old air compressor?
How old is this old air compressor?
Last edited:
MEP001
Well-known member
Husky is a good compressor but it MUST be broken in properly. I've seen many times where someone bought one, put it in the room, put oil in it and hooked it up, and the pump failed in about a year. They must be run continuously for 30 minutes to an hour (depending on the size - it's specified in the manual) with no load to seat the rings, otherwise it will constantly lose oil.
Ingersoll-Rand is pretty good, but they're overpriced and they use crappy motors. The pumps are the same ones both Husky and Speedaire use. I installed a "Black Max" as a back-up, which also uses the same pumps.
Anything you get that's rated continuous duty should serve you well, just read the manual and set it up the way you're supposed to.
Ingersoll-Rand is pretty good, but they're overpriced and they use crappy motors. The pumps are the same ones both Husky and Speedaire use. I installed a "Black Max" as a back-up, which also uses the same pumps.
Anything you get that's rated continuous duty should serve you well, just read the manual and set it up the way you're supposed to.
Rudy
Active member
Ditto Eaton Compressor. I can't say enough good things about my unit.....
soapy
Senior Member
Listen to any compressor you are going to buy. Many run very loud compared to others. American made Quincy industrial compressors have always been great for me. I have one in my wash that has been running for 18 years without a problem. The one I have in my detail shop was purchased in the 1960's and has never been serviced other than changing oil and for most of its life it served as the only compressor in a tire shop. They run much quieter than other I have been around.
The Black Max Air compressor was made by Sanborn. Coleman Power products bought out the Sanborn Air Compressor Company in 1994 and dropped the Black Max from the Coleman shortly thereafter. The Black Max is a good air compressor for a 4 bay car wash. Randall Why did you have to take it to the shop? There isn’t much on them that you can’t replace yourself?
cantbreak80
Maybe I need new clubs
What did I tell you...
...well, OK...I don't have to junk it but, today it started leaking from the pressure switch.
Gotta replace the in-tank check valve.
