I had some custom stainless steel towers made with two tips per Tower angled down to blast just the running boards on vehicles. I am unsure what tip sizes to use. It will be a cat 3535 pumping the water. What size tip would you recommend?
Running board Tower spray nozzle size
- Thread starter APW
- Start date
Eric H
Well-known member
Does this run at the same time as the power towers and undercarriage? If not, I’d be afraid that there wasn’t enough water flow.
Eric H
Well-known member
My newer undercarriage has 5 nozzles. The 3 middle are pretty wide and the outermost nozzles are narrow. I’ll try to check the size on them tomorrow and send a picture.
Eric H
Well-known member
Outside nozzles are 1505 and middle 3 are 4006.
Attachments
Thanks!
I.B. Washincars
Car Washer Emeritus
- Joined
- Aug 30, 2007
- Messages
- 4,289
- Reaction score
- 1,171
- Points
- 113
- Location
- SW Indiana melon fields.
On my Mark VII’s I had either #9 or 10’s in the UC. There were only 7 nozzles If I remember correctly, but I was pumping with a much smaller pump. It was very impressive to hear underneath the car. With a 3535 you should be able to put pretty much anything in there. Go big or go home.
