soapy
Senior Member
I used 1/8 th inch thick which is about the same as FRP and it runs $41.54 for a 4 by 8 foot sheet. compare that to FRP for a comparison.
Wall Paneling
- Thread starter DiamondWash
- Start date
JustClean
Active member
Is anyone using the Farmtec , Nu-form or Extrutec Panels in a hot climate area like Florida? Any experience with this? I know Extrutech is saying 120deg max heat exposure. But that might not be enough if the sun is hitting it directly at the entrance or exit...
my2cents
Member
FWIW: There was a company out of Canada called Delcan Products who had a competitive product to Extrutech. The main difference was not as thick but had thicker ribs for strength and also a wider tab. The finish was not quite as nice as Extrutech but it still looked good. I don't know how $$$ competitive.
