Wash Select II

[wisheewashee]

Have a Wash Select II. Noticed when someone is in wash, then a car behind puts money in, the wash will start over immediately after finishing the wash. Before they car has a chance to leave. Is this a stacking issue? It is as if the system is not waiting for the customer to leave the wash before the next one starts.

 

[garbageman]

What type of wash equipment do you have? Is this a new auto cashier that was just started up or has it been working for some time and is just now showing this problem? The wash select is only used to send a wash input to whatever wash equipment you have when it is prompted to while monitoring the wash in use or cycle complete. It is important to now what wash you have and what method, wash in use or cycle complete, you are using.

 

[wisheewashee]

Wash Select issue

What type of wash equipment do you have? Is this a new auto cashier that was just started up or has it been working for some time and is just now showing this problem? The wash select is only used to send a wash input to whatever wash equipment you have when it is prompted to while monitoring the wash in use or cycle complete. It is important to now what wash you have and what method, wash in use or cycle complete, you are using.

I have 1.0 Water Wizard. This is equipment that has been in use and this issue has just cropped up.

 

[Greg Pack]

Any luck with this? Also check your setting on your red lion HMI for unitec enabled