Wheel counter on Wizard

[wisheewashee]

Can anyone help me on how to set wheel prox settings? I had a customer complain that the boom scraped the back of his F-250. Have had no other complaints but want to make sure that the gantry is going far enough behind the vehicle

 

[washnvac]

Your safety eyes should keep that from happening. I think the prox counts a certain amount of pulses after the eyes make at the rear. I do not believe it is an item that can be changed. Have you checked your two sets of safety eyes?

 

[Tom Thumb]

The wheel prox setting can be changed at the read lion, factory setting is 10 ( I believe).
You may need to contact a serviceman at your dealer to get the password to allow you to reset.

 

[Greg Pack]

ditto on the eye check. The only time I have had trouble is when something strange on the back was not seen by the eyes. I think factory setting is 8 counts.

 

[wisheewashee]

I believe I have the password. How do you get to the settings?

 

[Tom Thumb]

Wisheewashee,

I have a extra copy of the manual for the Danfoss Drives, will be glad to mail too you.
E-mail and let me know if you are interested?