What's new
By:
Car Wash Forum

This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Ww 2.0

SSadmiral

SSadmiral

Young buck
Does anybody know where we can get the 2.0 banner eyes other than jcc? I called banner a while back and they told me the eyes where made for jcc and were proprietary / over priced

Thanks
 
You can now order them from any banner distributor but they aren't that much cheaper. I think some of the CW supply houses sell them.
 
I recently (w/in last couple months) ordered the eyes off of Banner's website. If I remember correctly, they were $40-50 less than JCC.
 
Ok so we may be talking about different eyes because I was told the same thing again from banner and KR said they don't have access to these eyes. The banner eyes I'm looking for are hard wired, not the quick disconnect.

I believe the receiver part number to be qs30ex-15606
 
cleaning up mud said:
jc went to hard wired because corrosion problems. I have not tried to find them anywhere since. We have both.
Click to expand...

For the hard wired right (qs30ex-15606 & qs30ARX-15616) now its available at JCC. I just got some from my distributor/technicians waiting on their invoice to see how much it cost. As for quick connect (QS30EXQP-74009 & QS30ARXQP-74010), available at several places . WalkerEMD, PLC, CWS, and ebay if ur lucky.
 
I will remind people that most of these problems with the eyes ARE the connector, and many non functioning eyes can be made functional by cutting the ends off and soldering the wires.

That modification, plus some plastic polish for the aging/clouded lens, makes these eyes are fairly durable.
 
Car wash hack - So I had a couple eyes that were acting up on me you know there going bad because you can see the green corrosion on the quick disconnect. For the hell of it I took FB 3/8 hose and slide directly over the connection then filled both ends with diaelctric grease. For good measure I zip tied the hose in place at both ends and voila been working great for over a month now with no more errors
 
That a good idea. I have used silicone sealant to solve some floor eye problems, but the silicone grease in the hose should work well.

In frustration in the past I have filled an entire floor eye box with a tube of silicone sealant. I believe that made my problem go away for years.

I'm finding that even after soldering and using marine grade shrink I'm eventually getting corrosion in the repaired connections. last week I had to replace a floor eye that I repaired in the past. The transmitter was stuck on channel two. However, I am using cheap harbor freight marine heat shrink. I will swap to a better grade ike 3m and see if the longevity improves.
 
You must log in or register to reply here.
Back
Top